DIY Gorechild good Chain Axe of Khorne

This is a Do it Yourself listing for Gorechild. This means that I will 3D print all of the parts, clean major supports, and ship you the pieces. It will then be up to you to glue the parts together and purchase any additional needed pieces. For this axe you will need PVC pipe for a handle.

As for adhesive, E6000 is available at most hardware stores, and even some craft stores. It has a long cure time, but it holds pretty well. Epoxy also works well. Superglue can work, but will not bond the pieces properly. However super glue to hold it in pace while the other adhesive cures has worked for me in the past. (Just don't mix adhesives, might be really bad)

The color of the 3D printed prop will vary depending on what filament I can get at the time. I will print using PLA+, a medium durability and heat resistant good material. I do not advise using this as an actual weapon, or pretending to hit someone. It does have some pointy bits.


I've had such strange interactions with people at hardware stores who measure internal vs external diameter.
The external diameter is 43mm, internal should be 1.5 inches.